Feed aggregator

Design engineers aiming to protect the input and output of op amps have several options. They can use an electrostatic discharge (ESD) diode or input current-limiting resistor alongside a transient voltage suppressor (TVS) diode. However, both design approaches have limitations. Here is why an op amp with integrated JFET input protection has better design merits.

Read the full article at EDN’s sister publication, Planet Analog.

Related Content

• Op amps: the 10,000-foot view
• Op-Amp Measurements Explained
• New op amps address new—and old—design challenges
• Are you violating your op amp’s input-common-mode range?
• Op Amp Circuitry Ultra-High-Precision Resistor Usage: Matching and Stability Importance

The post Build ESD protection using JFETs in op amps appeared first on EDN.

submitted by /u/Exploring-new [link] [comments]

Процес очищення стічних вод в університеті kpi ср, 02/05/2025 - 13:53

Intelligent power and sensing technology firm onsemi of Scottsdale, AZ, USA says that the Science Based Targets initiative (SBTi) has approved its near-term science-based emissions reduction targets. Validation of these targets attests that the planned decrease of onsemi’s greenhouse gas (GHG) emissions is aligned to the ambition of limiting global temperature rise to 1.5°C...

APC Electronics (APC-E) of Bend, OR, USA — which researches, develops and manufactures wide-bandgap power semiconductor products — has announced Luminus Devices Inc of Sunnyvale, CA, USA — which designs and makes LEDs and solid-state technology (SST) light sources for illumination markets — as its exclusive worldwide sales channel and go-to-market partner...